You asked for an auto version, we listened! The automatic cup holder version is finally here!

This cup holder is going to be for 4x4 AUTOMATIC trucks, that the transfer case shifter mounted on the side of the tunnel. IT WILL NOT FIT MANUAL TRANSMISSION TRUCKS. You will need to check out our other models for manual transmission. The Auto Trans version mounts to the top two existing holes of your t-case shifter bezel. There is an included brace since the thin floor tends to give some movement with only the 2 holes being used. The brace has a hole on the bottom, but it is not necessary to drill into the floor. It will brace just fine only bolted to the cup holder itself. A button head bolt and nylon lock nut will be included for bolting the brace to the cup holder.

Built into the cup holder is a molle pattern for universal mounting, you can attach things like phone mounts, knifes, radios etc. It also has a holster slot for mounting a kydex holster. All built in, no need for additional parts.

There are a few trucks that had a different transfer case, usually found in early 87 trucks. Please make sure your t-case boot looks like the one pictured, if it does not, this product will not work for you.

Offered in raw steel, or powder coat. Please understand raw steel may have slight imperfections, and is intended to be painted.

Mounting these can be pretty tricky. If the boot was ever removed and not installed back into factory holes it can be tough to get everything lined up. But we promise, it will fit. If you want a true flush fit of the bezel, trimming some of the internals from the bezel will be required, but it is not necessary to bolt up. Longer screws are HIGHLY recommended for an easier install. 100's of guys have successfully installed these. Incompetence is not reasoning for poor review. If you are looking for an easier install, look into our Console Cup Holders